This article is for the reader who is already knowledgeable about the fundamentals of Xbox overheating. He's already tried using his equipment from cool, well ventilated locations, from other sources of warmth, limits the hours of usage, keeps the vents clean of dust and obstacles, and retains the power brick free from carpeting. I will discuss how a terrible connection between the CPU and it's heat sink or the GPU and it's heat sink can lead to severe overheating issues.
In the best of circumstances, the Xbox has a cooling system that hardly keeps pace with normal heat buildup. Since it has small cooling capacity to spare, it does not tolerate abuse well. Many people would rather expect an Xbox, however badly abused, should take at least a couple of minutes to overheat.
So if your Xbox has got the two red light mistake (indicating overheating) in seconds of turning it on after a chilly start, you might be thinking about how this could be possible.
One reason for such speedy overheating is the fact that either the CPU or the GPU have become detached from their heat sinks. A heat sink is a device that pulls off extra heat. So as to do its job correctly, the heat sink must be in good thermal contact with the CPU (or GPU as the case may be).
A CPU or GPU can heat up extremely rapidly if it will get no heating at all. click here have a lot of power due to their size. Only a few seconds would be required with this electric power to overheat an un-cooled GPU or CPU. This overheating is so fast that the rest of the console wouldn't even have the time to heat up if the overheated CPU or GPU causes the Xbox to close down. So you end up with a console which still feels trendy but is flashing the two red light mistake.
There are a number of ways which the heat sink may shed thermal contact. Either the thermal adhesive is extremely old, or a lot of thermal paste was originally implemented, or there's no paste in any way. Maybe the wrong washers (too thick) were utilized during the assembly process or the heating were not bolted down properly or perhaps Microsoft left some foil on the heat sink.
When replacing the thermal paste, remember to wash off the old paste . An alcohol wipe ought to function for this. Avoid placing too much thermal paste as only a slim picture is required to make sure that there's no air pockets between the heat sink and the CPU (or even the GPU). A good adhesive to utilize is Arctic Silver. Keep track of the spacer washers that you eliminate since they have to be put back through reassembly.
If you've never attempted this before but are determined to do this yourself, it is strongly recommended that you get a manual for this type of repair. Also note your warranty is voided once you open the console. Good luck