Bad thermal adhesive is one of the most frequent reasons for Xbox overheating and the red ring of passing. This sometimes happens if the glue is applied during manufacture of this console. Bad paste can also lead to exposure to heat over long time periods. As the paste gradually breaks down, you will begin to experience an overheating problem that gradually worsens over time. If the glue fails fast, this will lead to an almost instantaneous two red light error in minutes of turning on your Xbox.


Whether you should make an effort to replace the thermal paste on your own depends on whether or not you wish to create use of your warranty. If you have never opened your games console earlier, then using your guarantee to get the problem fixed by Microsoft is the very best alternative. Just do not forget that after you do start the console, your guarantee will be voided.
It always helps when you understand why you're doing something, so little bit of concept will be discussed. Thermal paste acts like a bridge allowing heat to maneuver across the contact region between the heat sink and the CPU or GPU. When the paste breaks down, it functions as a barrier to heat as opposed to a bridge. This means the heat sink will not have the ability to perform its task of drawing heat from the GPU.

When applying thermal paste , try the following tips:
1.) Implementing new paste on top of the old does not do anything because the old glue will still block appropriate heat transfer. The old paste can be removed by employing rubbing alcohol using a sterile cloth. The surface ought to be shiny when you are finished. It is pointless to wash only one of the two mating surfaces. After cleaning, never touch the surfaces together with your fingers because this will leave oil in the form of a finger printing.

2.) Consistently use the paste in a thin coating. The thinner it is, the better it will work. Just make sure the whole surface is covered. You will know this when you can not see any of those shiny metal. A good rule of thumb would be to use a dab of paste concerning the size of a BB.

3.) By covering your finger tip with a little plastic bag, after that you can use your finger to apply the paste without leaving oils from your skin. This also gives you more control than attempting to do this using a stick.
4.) Arctic silver , a top quality thermal adhesive, is recommended.

5.) Keep all liquids away from the work area and don't do your job on a carpeting. Carpeting can cause static electricity that will damage the motherboard parts.